P2034
Exhaust Gas Temperature Sensor Circuit (Bank 2 Sensor 2)
P2034 is the general electrical fault of the second exhaust temperature sensor on bank 2, so it only appears where the second bank has its own measuring point downstream. GM does not use it: the 2018 diesel tables number every exhaust temperature sensor on bank 1 (P0545/P0546, P2032/P2033, P242C/P242D, P2470/P2471), as one aftertreatment line serves the whole engine. Deutz assigns P2034 on its EMR L1 engine controller (industrial engines, list of November 2022) to the second temperature sensor upstream of the SCR catalyst, with failure-type bytes: -13 open, -11 shorted to ground, -12 shorted to battery, -F0 ground fault, -1C supply out of range. Others split low and high readings into P2035 and P2036. With the reading lost, temperature-dependent DEF dosing or filter regeneration is usually limited.
Possible causes
- Sensor lead open or shorted where it runs along the hot exhaust high
- Sensing element failed after many heat cycles medium
- Water or corrosion in the sensor connector medium
- Sensor ground or supply from the control unit faulty low
Symptoms
- Engine warning lamp on
- DEF dosing or particulate filter regeneration restricted
- Engine power reduced on some applications
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2034
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.