P2032
Exhaust Gas Temperature Sensor Circuit Low (Bank 1 Sensor 2)
P2032 means the signal of exhaust gas temperature sensor 2 on bank 1 is below its valid range. What that means electrically depends on the sensor type. On the Opel/GM 2.0 CDTi in the Saab 9-5 (2010) sensor 2 sits in the particulate filter and its voltage falls as it gets hotter, so a reading below 0.4 V for more than 1 s points to a short to ground; the code is Type A there. GM's 2009 Duramax uses the opposite characteristic and fails below 0.307 V, equivalent to -40 °C, for 300 s, which is typical of an open or grounded signal. GM's 2018 diesels compare against a resistance-equivalent limit below 142 Ω as a Type B code, Ford's 2023 diesels against 0.10 V within 2 s. So check the wiring diagram before deciding whether low means a short or an open. Without the sensor the ECM cannot control filter temperature and usually blocks regeneration.
Possible causes
- Signal wire chafed to ground on the exhaust high
- Internal sensor failure medium
- Damaged or corroded connector medium
Symptoms
- Malfunction indicator lamp on
- DPF regeneration inhibited, soot load rises
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2032
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p2032-or-p2033-lby
- gsi.ext.gm.com/gmspo/mode6/pdf/2009/09OBDG01 DURAMAX Engine Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG04 Engine Diagnostics.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf