OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2029

Fuel Fired Heater Disabled

A fuel fired heater burns a small amount of the vehicle's fuel to warm coolant or cabin air, a common add-on on diesels with little waste heat. P2029 is a state code: the controller has taken the heater out of service, usually after repeated failed starts, flame-outs, overheating or an electrical fault. CARB counts fuel-fired passenger heaters among other emission sources for which each maker must get its own monitoring plan approved. No manufacturer documents P2029 publicly. Webasto's Air Top Evo shows the pattern: no start, flame loss, overheating and glow plug faults have their own codes, and after too many failures the heater locks out until a workshop releases it. So the real fault, often logged alongside as P2030 or a circuit code, has to be fixed before the lock is cleared. The engine runs normally; the cabin stays cold.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 29

Possible causes

  • Lock-out after repeated failed starts or flame-outs (fuel supply, glow plug, combustion air) high
  • Heater shut down after overheating, e.g. low coolant flow medium
  • Supply voltage too low or wiring fault to the heater medium

Symptoms

  • Little or no auxiliary heat, slow warm-up
  • Heater does not start when requested
  • Warning lamp depends on the manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2029

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication