P2024
EVAP Fuel Vapor Temperature Sensor Circuit
The fuel vapor temperature sensor tells the ECM how warm the vapor in the tank and canister is, which matters for leak tests that judge pressure or vacuum as the fuel cools after shutdown. P2024 is the unspecified electrical code for that circuit. On recent Audi models the sensor is built into the leak detection unit J909 at the charcoal canister. An Audi bulletin first issued in 2023 and revised in September 2026 covers 2022–2025 A3 to Q8 models: four-cylinder engines could store P2024, described as an electrical fault of the tank breather temperature sensor, although guided diagnosis expects P2026 for a low voltage at J909. The fix there is to follow the corrected test, not to replace parts. Without valid temperature the EVAP leak test cannot complete.
Possible causes
- Open or shorted wiring to the temperature sensor or leak detection unit high
- Misassigned fault entry in the ECM software (Audi 2022–2025) medium
- Leak detection unit with integrated sensor faulty medium
Symptoms
- Check engine lamp on
- EVAP readiness not set, possible inspection failure
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2024
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.