P2022
Intake Manifold Runner Position Sensor/Switch Circuit High (Bank 2)
P2022 sets when the bank 2 flap position input reads close to the supply voltage. Ford's limit is above 4.7 V for 5 s on its V engines with vacuum-operated runners (shown from 2024 as P2019 with failure byte 15); for the Touareg hybrid engine CGFA (2014) Volkswagen gives more than 4.88 V. Such a value is rarely real travel – it normally means the sensor ground or signal line is open so the input floats up, or the signal wire has contacted a 5 V or battery feed. Wiggling the harness while watching the live value helps to tell a broken wire from a failed sensor. With P2017 on bank 1 at the same time, check the common ground first. The flaps are usually left unpowered, so the engine runs on with slightly less low-speed torque.
Possible causes
- Bank 2 sensor ground or signal open high
- Signal wire touching a 5 V or battery feed medium
- Bank 2 position sensor open internally low
Symptoms
- Check engine lamp on
- Little or no change in drivability
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2022
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.