P2020
Intake Manifold Runner Position Sensor/Switch Circuit Range/Performance (Bank 2)
P2020 flags a bank 2 position signal that is electrically sound but does not fit what the flaps should be doing. On the CGFA hybrid V6 of the 2014 Touareg, Volkswagen triggers it when commanded and measured flap position are more than 40 % apart or the reported value leaves the 0–100 % window. Ford's summaries describe it as the bank 2 sensor travelling too far: the plates either miss the commanded position or the sensor reports travel beyond the normal stops, and four such events are needed. Because a sticking shaft, a broken lever or a vacuum fault looks the same to the sensor, P2020 often appears next to the stuck codes P2005 or P2007.
Possible causes
- Bank 2 flap shaft sticking or carbon-fouled high
- Broken lever or linkage between actuator and shaft medium
- Weak vacuum or leaking actuator diaphragm (vacuum systems) medium
- Sensor shifted or adaptation missing after repair low
Symptoms
- Check engine lamp on
- Reduced pull in the mid range or uneven idle
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2020
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.