OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P201C

Intake Manifold Runner Control Actuator Supply Voltage Low (Bank 2)

P201C reports that the electric flap actuator of bank 2 is not getting enough supply voltage. It only makes sense on V engines that give each bank its own powered actuator. No manufacturer documents P201C publicly. The bank 1 counterpart P201B is described by GM for its DC-motor swirl drive: the driver supply below 6 V while the relay feed is above 11 V, in 240 of 300 samples, Type B. That logic separates a weak battery, which would also pull the relay feed down, from a loss on the branch to the actuator. CARB treats such actuators as comprehensive output components and requires circuit faults to be found continuously. In practice the search starts at the fuse and supply pin of the bank 2 actuator. If both banks report a supply fault at once, look for a shared fuse or relay first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 1C

Possible causes

  • Fuse or relay feeding the bank 2 actuator failed high
  • Damaged supply wire or connector at the bank 2 actuator medium
  • Actuator electronics loading the supply down low

Symptoms

  • Malfunction indicator lamp on
  • Bank 2 flaps stop working

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P201C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication