P2018
Intake Manifold Runner Position Sensor/Switch Circuit Intermittent (Bank 1)
P2018 belongs to bank 1 and covers a flap position signal that drops out or jumps for short moments while it otherwise stays within limits, so neither the low nor the high code matures. Few makers publish it. Mitsubishi lists P2018 for the 2022 and 2023 Outlander with the 2.5 litre PR25DD engine as a bank 1 fault of the sensor that reports where the runner valve stands, logged after two trips with the warning lamp; a 2023 bulletin added its diagnostic page to the service manual. CARB requires such input components to be watched for circuit faults, which is why erratic feedback earns its own code. Loose pins, a cracked wire near the manifold or a worn sensor track are the usual suspects.
Possible causes
- Loose or fretted pins in the sensor connector high
- Wire cracked by engine movement or heat near the manifold medium
- Worn resistive track in the position sensor medium
Symptoms
- Warning lamp that comes and goes
- Often no noticeable change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2018
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.