OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2017

Intake Manifold Runner Position Sensor/Switch Circuit High (Bank 1)

P2017 is the mirror case of P2016: the bank 1 flap feedback is stuck near the supply rail. With a pulled-up input that happens when the signal or sensor ground opens, or when the signal wire touches a voltage source. Ford's limit is 4.7 V for 5 s, Volkswagen uses 4.85 V on the 3.0 TDI and 4.88 V on the 3.0 TSI hybrid of the 2014 Touareg. On GM's 2018 diesel swirl actuator the period is again pinned at 30 ms but the duty cycle reads 100 %, counted in 50 of 62 samples; the 2025 SENT version flags a raw value over 99 % in 480 of 600, both Type B with MIL after two trips. Chrysler's short runner valve bulletins cover P2017 together with P2016, which points to shared supply or connector faults rather than two failed parts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 17

Possible causes

  • Open sensor ground or signal circuit high
  • Signal wire shorted to the 5 V reference or battery voltage medium
  • Spread or corroded terminal in the valve or sensor plug medium
  • Position sensor or actuator electronics faulty low

Symptoms

  • Check engine lamp on
  • Flaps parked in default position, slightly changed running at part load

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2017

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication