OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2016

Intake Manifold Runner Position Sensor/Switch Circuit Low (Bank 1)

P2016 says the bank 1 flap position signal sits at the bottom of its range, typically a shorted signal wire or a lost 5 V supply. Ford sets it below 0.24 V after 5 s; the 2014 Touareg 3.0 TDI (CNRB) below 0.15 V. GM's 2018 diesels read a smart swirl actuator whose feedback is a pulse train: a period frozen at 30 ms with 0 % duty in 50 of 62 samples, at least 5 s after the actuator woke and above 11 V, gives a Type B fault. On GM's 2025 SENT sensor a raw value under 1 % in 480 of 600 samples does the same. Chrysler's short runner valve feedback uses it too: a PCM reflash for 2013–2015 Ram 1500 V6/V8 trucks addresses P2016, and a 2023 Ram case traced P2008, P2016 and P2017 together to a spread supply terminal in the valve plug.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 16

Possible causes

  • Signal wire chafed and grounded high
  • 5 V or actuator supply missing (spread terminal, blown fuse) medium
  • Position sensor or smart actuator electronics faulty medium

Symptoms

  • Check engine lamp on
  • Less torque at low revs or flat spot when the runner should switch

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2016

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication