OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2014

Intake Manifold Runner Position Sensor/Switch Circuit (Bank 1)

P2014 is the general electrical code for the flap position feedback on bank 1, used when the control unit sees a broken or shorted circuit without, or before, splitting it into low and high. Ford's 2012 summary calls it the IMRC input switch check: with coolant warmer than 40 °F it is checked all the time, and an open or shorted switch must persist for 5 s; from 2024 Ford treats P2014 as the base code whose failure bytes stand for low, high and over-travel. Volkswagen's quick reference for the 2014 Touareg sets it on the supercharged V6 hybrid (engine code CGFA) at a signal under 0.2 V. Volkswagen saw it on 2008–2011 2.0T engines (CCTA, CBFA) with failing manifolds and later told dealers on 1.8T/2.0T engines to replace only the sensor G336. The flaps then work unmonitored or are parked.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 14

Possible causes

  • Runner position sensor (VW G336) failed internally high
  • Sensor wiring broken or shorted medium
  • Manifold with integrated flap shaft and sensor damaged (VW 2.0T 2008–2011) medium
  • Corroded or loose sensor connector low

Symptoms

  • Check engine lamp on
  • Slightly weaker pull or rougher idle while the flaps are parked

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2014

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication