OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P200D

Particulate Filter Over Temperature (Bank 2)

P200D is the overheating code for a particulate filter on bank 2 and therefore only appears where the exhaust of the second bank has its own filter and temperature sensors. No manufacturer documents P200D publicly; the published diesel layouts of GM, Ford and Hino run one filter and report its overheating as P200C. Those tables show how such a limit is built: a fixed ceiling between roughly 800 and 950 °C on the sensor ahead of or behind the filter, confirmed over many samples or a few seconds, and stored at once with the warning lamp. On a twin-filter engine the bank 2 check looks only at its own sensors, so a fault limited to one side, such as one leaking injector, an overloaded filter on that bank or a skewed sensor, separates the two codes. The control unit will usually stop regeneration and may limit power.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 0D

Possible causes

  • Bank 2 filter overloaded with soot before regeneration high
  • Leaking injector or excess fuel on bank 2 cylinders medium
  • Exhaust temperature sensor on bank 2 reading too high low

Symptoms

  • Malfunction indicator lamp on
  • Regeneration stopped
  • Power may be limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P200D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication