OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0EF4

Drive Motor C Temperature Sensor Circuit High

P0EF4 reports a drive motor C temperature signal above the plausible window. For an NTC sensor on a pull-up this equals an impossibly cold winding, the picture produced by an open sensor, a broken wire, an unplugged connector or a short to the reference voltage. No manufacturer documents P0EF4 publicly. GM's ELR motor controller treats the same situation for motor B as P0A33 once the value reads below −41 °C, near 5 V, while Ford flags the coil sensor of its 2019 hybrids once the voltage exceeds 4.8 V for 32 ms. A sensor that claims far too low a temperature would hide real overheating, so the controller switches to a substitute value and limits the output of motor C. Check the connector at the motor first; the low-side sibling is P0EF3.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / F4

Possible causes

  • Sensor connector unplugged, loose or with pushed-back pin high
  • Broken signal or ground wire of the sensor medium
  • Thermistor open internally medium
  • Signal wire shorted to the 5 V reference low

Symptoms

  • Reduced power of motor C
  • Motor temperature stuck at the lowest value in the live data
  • Warning lamp on

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0EF4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication