OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0EF3

Drive Motor C Temperature Sensor Circuit Low

P0EF3 is stored when the signal voltage of the drive motor C temperature sensor drops below its valid range. With the usual NTC thermistor on a pull-up resistor, a low voltage stands for an extremely hot winding, so electrically the suspects are a short to ground, a pinched harness or a sensor with an internal short. No manufacturer documents P0EF3 publicly. GM's motor B table for the 2016 Cadillac ELR shows the analogous limit: P0A32 trips once the reading corresponds to more than 184 °C, close to 0 V, after a 90 s warm-up, Type A. Ford's 2019 hybrids fail the motor coil sensor below 0.1 V held for 32 ms. Because the controller cannot tell such a short from real overheating, it derates motor C. P0EF4 covers the high-voltage side.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / F3

Possible causes

  • Signal wire shorted to ground or motor housing high
  • Thermistor shorted internally medium
  • Water or coolant in the connector bridging the pins medium

Symptoms

  • Drive power of motor C reduced immediately
  • Implausibly high motor temperature in the live data
  • Warning lamp on

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0EF3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication