P0EED
Hybrid/EV Battery System Discharge Circuit Performance
P0EED concerns the active discharge path on the high-voltage side, the circuit that drains the DC link capacitors once the contactors have opened so that no dangerous voltage lingers. The code says this path does not perform as intended, whereas P0C76 only judges how long the voltage takes to fall. FCA lists P0EED-00 for the 2017 Chrysler Pacifica Hybrid in bulletin 08-107-17, next to P0C76, P0C77 and P0AFA: a loose terminal bolt where the high-voltage lead joins the inverter module (PIM) could arc, the MIL came on and propulsion might be lost. Repair was a torque check to 25 N·m, or a new inverter module and cable if arcing marks were found. As a reference for the timing side, GM's P0C76 fails when the inverter still reads above 200 V 3.5 s after opening, Type A.
Possible causes
- Loose or arcing high-voltage cable terminal at the inverter module (FCA 08-107-17) high
- Discharge resistor or its switching transistor open or degraded medium
- Internal fault in the inverter or its voltage measurement medium
- Main contactor sticking closed so the bus stays charged low
Symptoms
- MIL or hybrid system warning on
- Loss of propulsion or vehicle will not enter ready mode
- Further high-voltage codes such as P0C76 or P0C77 stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EED
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.