OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0EE8

Battery Charger Coupler Temperature Sensor B Circuit Range/Performance

P0EE8 is set when sensor B in the charging inlet delivers an electrically valid value that does not fit the situation. A plausibility test may compare it with sensor A on the neighbouring pin, with the outside temperature after a long rest, or with the heating expected for the charge current. If B reads far colder than A during a high-current session, or shows a sudden rise without current, it fails. No manufacturer documents P0EE8 publicly. GM gives a hint for the A sensor equivalent P0D9A on the 2022 Hummer EV and BrightDrop EV600: worn or oversized terminals in public charge plugs are a suspect, and the test only runs again after about ten minutes of driving above 2 mph (PIT5904). Inlets with two DC pin sensors, as Sailtran builds them, make such a cross-check possible.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / E8

Possible causes

  • Worn station plug heating one contact unevenly medium
  • Drifting sensor element B medium
  • Sensor B lost thermal contact to its pin low

Symptoms

  • Charging reduced or aborted
  • Fault only at certain stations

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0EE8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication