OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0EE6

A/C Refrigerant Distribution Valve B Control Circuit Driver Current/Temperature Too High

P0EE6 is reported by the output stage itself: the switch that powers refrigerant valve B has measured too much current or got too hot and has protected itself. Modern smart high-side switches do this on chip; TI's TPS1HB16-Q1, for example, has an adjustable current limit between 4.4 and 49 A, shuts down at about 150 C junction temperature with roughly 20 C hysteresis, and flags the event on its diagnostic output. A coil drawing more current than normal, through shorted turns or a partial short in the wire, is the usual cause; a hot mounting spot of the module can add to it. No manufacturer documents P0EE6 publicly. Unlike P0EE4, the circuit still conducts and is not simply grounded. The same driver fault on valve A is P266F; Audi's A7 PHEV logs a valve B fault in J1024.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / E6

Possible causes

  • Shorted turns in the valve B coil raising the current high
  • Partial short in the valve wiring medium
  • Control module output stage overheating low

Symptoms

  • Warning lamp on
  • Valve B switched off, cooling branch not served

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0EE6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication