OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0EE3

A/C Refrigerant Distribution Valve B Control Circuit/Open

P0EE3 concerns the wiring between the controlling module and refrigerant valve B, most often an interrupted path. With the output switched off, the driver normally sees a defined voltage through the coil; with it switched on, current flows. If neither picture appears, for instance because a pin has backed out of the connector or the coil winding is broken, the circuit is declared open. No manufacturer documents P0EE3 publicly. That valve B exists as a separately monitored part is shown by Audi's A7 PHEV, whose thermal management unit J1024 reports its mechanical fault as P0EE200. Typical hardware is a 12 V solenoid like Egelhof's shut-off valves. CARB requires every electronic output used for battery thermal management to be checked for open circuits. The matching valve A code is P2611.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / E3

Possible causes

  • Loose, corroded or pushed-back pin at the valve connector high
  • Broken coil winding in valve B medium
  • Broken wire in the harness to the valve medium

Symptoms

  • Warning lamp on
  • Valve B no longer switches, affected refrigerant branch stays as it is

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0EE3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication