P0EDC
Generator Phase Z Current High
P0EDC is the overcurrent code for phase Z of the hybrid generator and ends the X-Y-Z series. No manufacturer documents P0EDC publicly; the closest published logic is Ford's for its U-V-W generator phases (P0A71, P0A74, P0A77), which also flags any current above 15 A in the first 200 ms after power-up, a moment when the machine should be idle. A reading like that hints at a switch leaking or stuck on rather than at load. During operation a short between winding turns, an insulation fault to the housing, a damaged power module or a sensor with excessive gain can be behind the code; a sensor error usually also upsets the three-phase sum check. After the protective shutdown the generator no longer charges and electric engine starting may fail. Low side: P0EDB.
Possible causes
- Damaged or leaking power module for phase Z medium
- Insulation fault or turn short in the phase Z winding medium
- Current sensor with excessive gain medium
Symptoms
- Hybrid system shutdown, engine may not start
- MIL and hybrid warning, possibly with sum check codes
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EDC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.