P0EDB
Generator Phase Z Current Low
P0EDB means phase Z of the hybrid generator shows less current than the commanded operating point calls for. No manufacturer documents P0EDB publicly. Besides an absolute floor, published checks also look at the gap between actual and target current: Mitsubishi's Outlander PHEV fails a U-V-W phase not only when it hovers near zero under demand but also when it misses its target current. If phase Z falls short, the machine runs unbalanced, which causes torque ripple, humming and extra heat in the remaining phases, so the inverter lowers generator power. Likely causes are a loose or corroded high-voltage terminal, a broken lead in the winding, a power switch that no longer conducts or a sensor offset. High counterpart: P0EDC; general code: P0EDA.
Possible causes
- Loose or corroded phase Z high-voltage terminal high
- Broken conductor in the phase Z winding low
- Power switch for phase Z no longer conducting medium
- Phase Z current sensor offset low
Symptoms
- Humming or vibration from the hybrid transaxle
- Reduced generator power and charging
- MIL and hybrid warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EDB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.