OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0EDA

Generator Phase Z Current

P0EDA is the general current fault of phase Z, the last of the three X-Y-Z generator phases, without the detail of P0EDB (low) or P0EDC (high). No manufacturer documents P0EDA publicly. In a three-phase set the currents add up to almost zero at every instant, so a controller can calculate one phase from the other two or use the sum as a cross-check; Mitsubishi's Outlander PHEV, for instance, fails its generator sum check P0DFA when, with the switches off, the sum stays at 140 A or above for 0.35 s. A faulty Z current therefore often shows up together with sum or correlation faults. Under CARB these drive components must be supervised as well. Expect a hybrid system warning and limited generator operation. Phases X and Y: P0ED4, P0ED7.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / DA

Possible causes

  • Phase Z current sensor offset or failure high
  • Inverter fault on the phase Z bridge medium
  • Poor contact at the phase Z high-voltage terminal low

Symptoms

  • Hybrid warning, often with further phase or sum codes
  • Reduced charging and generator assist

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0EDA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication