P0ED9
Generator Phase Y Current High
P0ED9 is set when phase Y of the hybrid generator draws more current than allowed. No manufacturer documents P0ED9 publicly. Overcurrent in a generator phase is a protection event: the inverter must switch off within fractions of a millisecond, before its power semiconductors are destroyed. The scale is illustrated by Ford's limits for the U-V-W phases, 300 A for 400 microseconds in operation. Causes include a short between turns or to ground in the Y winding, a chafed phase cable and an inverter switch stuck on; a sensor that reads high can imitate the fault. If several phases report high at the same moment, the inverter or its common supply is more likely than three separate defects. Low side: P0ED8; the same fault on phase X: P0ED6.
Possible causes
- Short in the phase Y winding or to the housing medium
- Inverter switch stuck on medium
- Chafed phase cable shorting to ground low
- Current sensor reading too high medium
Symptoms
- Hybrid system shuts down, vehicle may lose ready mode
- MIL and hybrid warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ED9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.