OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0ED8

Generator Phase Y Current Low

P0ED8 reports too little current in phase Y of the hybrid generator. No manufacturer documents P0ED8 publicly. Ford's 2019 hybrid summary describes a phase circuit test at power-up for the U-V-W phases: the motor/generator control unit declares a phase circuit fault if less than 5 A is seen over the 100 ms test window. Seen this way, a low Y current is first of all a question of continuity: an open cable or terminal, a failed winding joint or an inverter switch that does not turn on. A sensor that reads too low would make the controller drive more real current than intended, so a low code from the sensor side deserves the same attention. Generator torque and charging power drop. High counterpart: P0ED9; same fault on phases X and Z: P0ED5, P0EDB.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / D8

Possible causes

  • Open or corroded phase Y cable or terminal high
  • Inverter switch for phase Y not turning on medium
  • Phase Y current sensor reading too low low

Symptoms

  • Generator delivers less charging power
  • Uneven running or noise from the transaxle
  • MIL and hybrid warning

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0ED8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication