P0ED7
Generator Phase Y Current
P0ED7 is the general current code for phase Y, the middle phase of the generator's X-Y-Z set. Without being narrowed to low (P0ED8) or high (P0ED9), it says that the Y current no longer behaves as the inverter controller expects. No manufacturer documents P0ED7 publicly, and it is not known which production machines label their phases X, Y and Z. Ford describes what phase currents are used for in its 2019 hybrids: sensors on each phase feed the motor/generator control unit, which needs them to work out current magnitude and angle and also to confirm that the three AC cables are connected the right way. Monitoring of such electric drive parts is mandatory under CARB. Check the high-voltage connectors and look for other phase codes. Phase X: P0ED4, phase Z: P0EDA.
Possible causes
- Inverter fault affecting the phase Y bridge high
- Phase cables mixed up or poorly seated after repair work low
- Phase Y current sensor fault medium
Symptoms
- Hybrid warning and MIL
- Limited generator operation
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ED7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.