P0ECB
Hybrid/EV Battery Voltage Sensor System - Multiple Sensor Correlation
P0ECB indicates that the voltage measurements of the hybrid/EV battery contradict each other. Battery controllers usually capture the same voltage along more than one path, for example the whole pack directly and as the sum of all cell readings, or each half of the pack against its own cells; once these paths drift apart, at least one sensor must be wrong. No manufacturer documents P0ECB publicly. GM runs exactly this comparison under P0ABB: a gap of more than 12 V between pack voltage and cell sum in 20 of 25 samples is a Type A fault. Ford checks each half pack against the total of its cells and fails above 42 V on plug-in and 38 V on full hybrids held for one second (P0B15, P0B1A). Since state of charge is no longer reliable, power is limited.
Possible causes
- Drifting pack or half-pack voltage sensor in the battery controller high
- Loose or corroded cell sense lead falsifying the cell sum medium
- Internal fault of the cell monitoring electronics medium
- Measurement taken on the wrong side of a contactor that is not fully closed low
Symptoms
- MIL and hybrid system warning
- Limited electric power, unstable state of charge display
- Contactors may stay open, vehicle may not reach ready mode
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ECB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.