P0ECA
Hybrid/EV Battery Temperature Sensor System - Multiple Sensor Correlation
P0ECA treats the temperature sensors of the hybrid or traction battery as one system: the battery controller compares the readings with each other and flags the group when one of them strays from the rest or shows an impossible value. Ford documents it for its 2019 hybrid and plug-in models. The BECM runs the check all the time and sets P0ECA after three or more 5-second events in which a thermistor deviates from the average by more than 25 °C, reads above 95 °C or reads below −50 °C. Bentley stores P0ECA00 in address 0021, the 48 V super capacitor of the Bentayga's Dynamic Ride, alongside P0A9E and P0AC8; the cure is software version 114, after which the part number ends in F. GM files comparable checks under single-sensor codes such as P0A9C instead. Battery power is reduced.
Possible causes
- One battery thermistor drifting away from the others high
- Battery controller software misjudging the comparison (Bentley super capacitor, update 114) medium
- Loose or corroded connector on the temperature sense harness inside the pack medium
- Genuine local hot spot, e.g. a blocked cooling channel at one module low
Symptoms
- Hybrid or battery warning, MIL depending on manufacturer
- Reduced electric power or charging rate
- On the Bentayga, Dynamic Ride fault message and no roll compensation
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0ECA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.