P0EC3
A/C Refrigerant Temperature Sensor B Circuit Low
P0EC3 stands for a sensor B signal pulled down toward ground. Because a thermistor of the NTC type lowers its resistance as it warms, the module reads a refrigerant temperature far above anything the system could reach. Typical culprits are a harness pinched against the body, water inside the plug or a sensor that has failed shorted. P0EC3 appears in no public manufacturer document. GM's evaporator sensor check on the 2012 Volt (P0537, below roughly 0.1 V, two trips) is the nearest documented model. On cars that cool the traction battery through the refrigerant loop the controller may restrict that cooling as well as the cabin A/C. Open-circuit side: P0EC2; sensor A equivalent: P0EBE.
Possible causes
- Harness pinched against the body, signal shorted to ground high
- Water ingress in the sensor plug medium
- Sensor B shorted internally medium
Symptoms
- A/C compressor held off, cabin not cooled
- Charging or driving power possibly limited if battery cooling depends on the loop
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0EC3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.