P0EB9
A/C Compressor Motor Phase W Current Sensor Circuit Low
P0EB9 is stored when the phase W current signal drops beneath its lower limit, for instance after the signal wire has made contact with ground or after the sensor has lost its feed. The value is then useless for motor control, and the compressor module shuts the drive down rather than run it on two phases of information. No manufacturer documents P0EB9 publicly. GM's 2011 Volt shows a comparable test: minus 68 A or lower on phase W at standstill set the older code P0D7F, rated Type B with MIL after two trips. Because the sensing sits inside the compressor, repair usually means replacing the compressor assembly once wiring and high-voltage plugs have been checked. High range: P0EB8; plausibility: P0EBA; general W circuit: P0EC0.
Possible causes
- Phase W measuring line shorted to ground medium
- Phase W sensor without supply medium
- Defect of the W measurement inside the compressor module medium
Symptoms
- No cooling, compressor silent
- Climate fault indicated
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EB9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.