P0EB4
A/C Compressor Motor Phase U Current Sensor Range/Performance
P0EB4 concerns the plausibility of the phase U current reading of an electric A/C compressor. The value is in range but disagrees with what the controller can work out for itself: in a motor fed by three wires the phase currents must add up to roughly zero, and each phase should follow the commanded current pattern. A standing offset or a wrong gain while running are typical findings. No manufacturer documents P0EB4 publicly. GM's 2011 Volt looked for offsets on its compressor phases only with the motor stopped (plus or minus 68 A, older codes P0D7A and P0D7B). A weakening sensor element or inverter board is the usual cause, so the compressor assembly gets replaced. Electrical faults of phase U are P0EB1 to P0EB3.
Possible causes
- Offset or gain drift of the phase U sensor high
- Ageing measurement circuit on the inverter board medium
- Winding fault in the compressor motor distorting the currents low
Symptoms
- Compressor runs roughly or noisily before switching off
- Reduced or intermittent cooling
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EB4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.