P0EB3
A/C Compressor Motor Phase U Current Sensor Circuit Low
P0EB3 means the phase U current signal has fallen below its permitted range. Depending on the sensor design this looks like a large negative current or like no signal at all; either way the controller can no longer trust the U-phase value it needs to drive the motor smoothly. No maker documents P0EB3 publicly. In GM's 2011 Volt, a phase U reading of minus 68 A or lower with the compressor at rest set the older code P0D7B, Type B with MIL after two trips, and a 12 V reset was needed before the test could pass again. Likely causes are a ground short in the sensing path, lost sensor supply or an internal inverter fault. Cooling stays off until the fault clears. Counterpart: P0EB2; the same fault on V and W: P0EB6, P0EB9.
Possible causes
- Phase U sensing path shorted to ground medium
- Supply to the phase U sensor missing medium
- Internal fault in the compressor inverter medium
Symptoms
- Air conditioning inoperative
- Fault message after switching the A/C on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EB3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.