P0EB2
A/C Compressor Motor Phase U Current Sensor Circuit High
P0EB2 is set when the phase U current sensor of the electric A/C compressor sends a signal above its valid window. Current sensors in such inverters often output a voltage centred on zero current, so a stuck-high output reads like a large current in one direction even with the motor at rest. No manufacturer documents P0EB2 publicly. GM's 2011 Volt ran a standstill test that catches exactly this: plus 68 A or more on phase U with no speed request set the older code P0D7A, Type B. A short to the sensor supply, a damaged Hall element or a fault on the inverter board are typical. The compressor controller stops the motor to protect the power stage. P0EB3 covers the low side; P0EB5 and P0EB8 report the same fault on phases V and W.
Possible causes
- Phase U signal shorted to the sensor supply medium
- Damaged Hall element of the phase U sensor high
- Defect on the inverter board affecting the U channel low
Symptoms
- Compressor will not start or stops at once
- No cooling during hot weather
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EB2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.