P0EAF
A/C Compressor Motor Current Sensor Circuit Low
P0EAF reports that the compressor current signal sits at the bottom of its measuring range. In a running compressor this cannot be true, so the module suspects the measuring chain: a grounded signal path, a sensing chip without supply or an offset error inside the power module. No manufacturer documents P0EAF publicly. GM's 2011 Volt supervises the measured current only against upper limits (27 A over 30 of 60 samples for P0D6F, 60 A on a single sample for a maker code), and Audi documents only the plausibility sibling P0EAE. Without a valid current value the controller cannot protect the inverter, so it shuts the compressor down. Air conditioning stops working while the car itself remains fully drivable. The high counterpart is P0EB0.
Possible causes
- Current signal path shorted to ground medium
- Current sensor without supply voltage medium
- Offset error of the measurement in the power module medium
Symptoms
- Compressor shut down, warm air from the vents
- Climate system fault message
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EAF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.