P0EAD
A/C Compressor Motor Current Sensor Circuit
P0EAD covers the current sensor of an electric A/C compressor, which measures how much current the motor drive takes from the high-voltage link. The controller needs this value to limit power and to shield the power stage and the high-voltage pack from overload. P0EAD is the general circuit code: the reading is absent or useless as a whole, with no low, high or plausibility verdict. Only Audi documents a sibling publicly (P0EAE on the 2016 A3 e-tron); P0EAD itself appears in no manufacturer source. GM's 2011 Volt shows how the measured value is used: above 27 A in 30 of 60 samples while the motor runs gives P0D6F, Type B. Because the sensor sits inside the compressor's power module, repair normally means the compressor assembly. Specific faults are P0EAE to P0EB0.
Possible causes
- Failed current sensing element in the compressor power module high
- Open internal connection between sensor and control board medium
- Compressor or climate module software error low
Symptoms
- Compressor does not start, no cooling
- Fault stored in the climate or compressor module
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0EAD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.