OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0EA7

Auxiliary Cooling System Performance

P0EA7 reports that an auxiliary cooling loop, a coolant circuit kept apart from the main engine circuit, does not achieve the cooling effect the controller expects. Volvo documents the code for its T8 plug-in hybrids of model years 2016 to 2019 (XC90, S90, XC60, S60 and others): the engine control module stores P0EA773, fault type actuator stuck closed, and turns on the check-engine light. Technical Journal 34123 traces it to the thermostat in the cooling coil of the electric rear axle drive and calls for a revised part with a small orifice, fitted in the correct orientation, followed by a coolant refill. Ford lists P0EA7:19 among codes that faulty dynamics-module software can leave in the PCM of the 2025-2026 Mustang GTD; reprogramming cures it there. Sensor faults of the same loop are P0E81 to P0E84.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / A7

Possible causes

  • Thermostat in the auxiliary loop sticking closed (Volvo T8, earlier part design) high
  • Low coolant level or trapped air in the auxiliary loop medium
  • Weak or failed auxiliary coolant pump low
  • Module software reporting the fault wrongly (Ford Mustang GTD) low

Symptoms

  • Check-engine light on
  • Often no noticeable change in driving behaviour
  • Possible power limits on electric drive parts that run too warm

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0EA7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication