OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E9D

DC/DC Converter Current Sensor B Circuit Low

P0E9D reports that the signal of DC/DC converter current sensor B has dropped below its valid range. Porsche documents it for the Taycan of model years 2020 to 2024 as P0E9D00, current sensor 2 of the converter with a short to ground, logged by the HV power electronics on the front axle (A49), the rear axle (A50) or both. A red warning tells the driver to stop safely because of an electrical fault, yet once the ignition has been cycled the entry is no longer active. Porsche blames a diagnostic threshold for current monitoring that was set too low and reprograms both control units, using PIWIS Tester version 43.500.000 or newer. Outside that case a real ground short or a dead sensor supply is the likely cause. The high counterpart is P0E9E.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 9D

Possible causes

  • Current monitoring threshold set too low in the software high
  • Sensor B signal shorted to ground medium
  • Sensor supply missing inside the power electronics low

Symptoms

  • Red warning to stop the vehicle safely
  • Fault no longer active after an ignition cycle
  • Drive power reduced or vehicle not ready to drive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E9D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication