P0E9C
DC/DC Converter Current Sensor B Circuit Range/Performance
P0E9C means current sensor B of a DC/DC converter gives a value within its electrical window that does not match the operating state, for example a current that stays put while the load changes, or that differs from the figure the controller derives from voltages and switching. No manufacturer documents P0E9C publicly. Ford describes such a rationality test for the boost converter of its hybrids under P0A94: a gap above 50 A between calculated and measured inductor current, lasting over 4 s in controlled operation, flags the converter. FCA treats the equivalent sensor A code P0E52 on the Ram 1500 eTorque as a one-trip fault after a software update. Circuit faults of sensor B are P0E9B, P0E9D and P0E9E.
Possible causes
- Current sensor B drifting or with a shifted zero point medium
- Fault in the converter power stage causing unexpected currents medium
- Software with an unsuitable plausibility window low
Symptoms
- MIL, sometimes after a single trip
- Reduced converter output and weak 12 V charging
- Power reduction warning possible
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E9C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.