P0E9A
DC/DC Converter Voltage Sensor C Circuit Intermittent/Erratic
P0E9A completes the sensor C voltage series of a DC/DC converter. It is meant for a signal that jumps, flickers or drops out for brief moments, which the low and high tests miss because they need a fault to persist. No manufacturer documents P0E9A publicly. The GM tables for channels A and B (25OBDG03A) illustrate the gap: their limit checks sample every 12.5 ms and require 320 failures in a window of 400, roughly four seconds, before a code is stored. Under CARB rules inputs need circuit and range tests and, if possible, a check for implausible values; an erratic code covers the cases in between. Corroded pins, a solder joint with a hairline crack or a wire that rubs through under engine movement are the usual causes, so the warning may come and go.
Possible causes
- Loose or corroded terminal in the sensor C path high
- Harness chafing intermittently at a moving point medium
- Cracked solder joint in the converter's measuring circuit low
Symptoms
- Warning lamp that appears and disappears
- Short interruptions of start-stop or 12 V support
- Code often stored as history only
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0E9A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.