P0E97
DC/DC Converter Voltage Sensor C Circuit Range/Performance
P0E97 is the plausibility code for the third voltage channel of a DC/DC converter: sensor C delivers an electrically valid value that does not agree with what the controller expects. Two makers document it. Audi names P0E9700 for the 2020-2021 Q5 and 2021 A7 plug-in hybrids, stored now and then by the J841 electronics of the electric drive, with symptom code 45146; the revised bulletin explains that the software ignored the tolerance of two capacitors, so the ratio between capacity A and B fell outside its limit, and new software (version 0102) cures it. Mercedes-Benz lists P0E9700 for the converter of the EQB and the G-Class after a faulty wake-up of that unit. Hard faults of sensor C are P0E96, P0E98 and P0E99.
Possible causes
- Converter or power electronics software with too tight plausibility limits high
- Converter stuck in an error state after an incorrect wake-up medium
- Drifting voltage measurement inside the converter low
Symptoms
- MIL on, often without a noticeable driving fault
- 12 V battery or high-voltage warning messages in the cluster
- Fault entry appears sporadically and returns after clearing
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E97
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.