OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E94

Drive Motor B Inverter Voltage Sensor B Circuit High

P0E94 records that voltage sensor B in the drive motor B inverter reports a value at the top of its signal range. A short from the signal to a supply, an interrupted sensor ground or a defective measuring stage are the usual explanations; a genuine overvoltage would normally show on the other channels too. No manufacturer documents P0E94 publicly. For sensor A of the rear motor Mitsubishi publishes the high limit on the 2023 Outlander PHEV: P0DA6 needs a signal of at least 4.76 V lasting 0.3 s, and only while the propulsion system is active, so the check is not run in standby. The low side of sensor B on motor B is P0E93, the high side of sensor B on motor A is P0E8F. CARB requires out-of-range checks for such inputs. Expect the second motor to be taken offline and a warning with MIL.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 94

Possible causes

  • Measuring stage for channel B in the motor B inverter defective high
  • Signal shorted to a supply or lost sensor ground medium
  • Real overvoltage on the high-voltage bus low

Symptoms

  • MIL and EV system warning
  • Second drive motor deactivated, less traction and power

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E94

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication