P0E8F
Drive Motor A Inverter Voltage Sensor B Circuit High
P0E8F is the upper-limit fault of inverter voltage sensor B on drive motor A. Mitsubishi's 2023 Outlander PHEV sets it when the main channel at capacitor 2 (V2M) reports at least 4.75 V for 0.16 s, again with the unit supplied at 8 V or above, and lists it as a range check maximum. A reading pinned at the top usually comes from the signal touching the sensor supply, from a lost sensor ground or from a defect in the measuring circuit. A real overvoltage of the bus cannot be ruled out, but it has its own code, P0C79, and would normally show on several channels at once; if sensor A (P0D30) and the battery voltage are normal, the B channel itself is suspect. P0E8E is the low counterpart. The controller protects the inverter by limiting or stopping electric drive.
Possible causes
- Measuring circuit for capacitor 2 inside the power drive unit defective high
- Signal shorted to sensor supply or lost sensor ground medium
- Actual overvoltage on the high-voltage bus low
Symptoms
- MIL and hybrid system warning
- Electric drive switched off or strongly reduced
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E8F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.