OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E8E

Drive Motor A Inverter Voltage Sensor B Circuit Low

P0E8E means the output of inverter voltage sensor B for drive motor A has fallen to the bottom end of its scale. On the 2023 Outlander PHEV Mitsubishi assigns it to the main measuring channel of capacitor 2 (V2M) in the power drive unit and sets it when that signal stays at no more than 0.45 V for 0.16 s, provided the unit has at least 8 V supply; monitoring runs continuously. Electrically this matches a short to ground, a broken signal path or a sensing circuit that has died, because the high-voltage bus itself would rarely read near zero while the system is active. The same channel reading high is P0E8F, while capacitor 1 on sensor A uses P0D2F for its low case. As the controller cannot trust the bus voltage, electric drive is limited or switched off and the MIL comes on.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 8E

Possible causes

  • Measuring circuit for capacitor 2 inside the power drive unit failed high
  • Signal line shorted to ground or open medium
  • No high voltage on the bus because of a blown fuse or open contactor path low

Symptoms

  • MIL and hybrid system warning
  • Vehicle not ready to drive or only engine power available

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0E8E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication