P0E8A
Battery Charger B Input Current Sensor Circuit
P0E8A concerns the measurement, not the current itself: the sensor that tells charger B how much current enters at its input delivers no usable signal. It is the general circuit code; range, low and high faults of the same sensor sit at P2D85, P2D83 and P2D84, and the sensor of charger A uses P0D38. No manufacturer documents P0E8A publicly. That the B input current is evaluated is clear from P0E89, which Toyota sets on the RAV4 Prime as a circuit current above threshold and Ford tests against a 100 A limit. CARB requires inputs such as this to be checked for open circuits and out-of-range signals. In most chargers the sensor sits inside the unit, so a confirmed fault usually means repairing or replacing the charger. Without the reading, charging is refused or stopped.
Possible causes
- Current sensor or its evaluation inside charger B defective high
- Open or shorted sensor wiring where the sensor is external medium
- Charger software misjudges the sensor signal low
Symptoms
- AC charging does not start or is aborted
- Charging fault indication; driving remains possible
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E8A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.