P0E87
Battery Charger B Input Voltage Too High
P0E87 flags an input voltage for charger B above what the charger accepts. Ford uses the code in its plug-in hybrid OBD summary (OBDSM1901) in an unusual way: it is part of a plausibility test run on the battery controller (BECM) and judges the charging voltage request that reaches the charger. Once the charger is in its ready state, a requested value above 450 V counts as a fault, and the check needs less than one second. In that reading the code points to a wrong command over the network rather than to the grid, so module software and data on the bus deserve attention first. On other designs a measured overvoltage at the input would set it. Ford lets charger faults request the amber wrench lamp instead of a specific charging message. The low case is P0E86.
Possible causes
- Implausible charging voltage request from the battery control module (Ford logic) high
- Software fault in the charger or battery control module medium
- Real overvoltage from the supply or charging station low
Symptoms
- Charging is refused or ends early
- Amber wrench lamp in the instrument cluster (Ford)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0E87
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.