OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E83

Auxiliary Cooling System Coolant Temperature Sensor A Circuit Low

P0E83 means the signal voltage of temperature sensor A in the auxiliary cooling loop has fallen below its valid floor. Coolant sensors are normally NTC thermistors whose resistance drops as they warm, so a low voltage reads as extremely hot coolant. When the value is beyond anything physically possible, the cause is usually a signal wire touching ground or a shorted sensor rather than real overheating. No manufacturer documents P0E83 publicly. On Ford's 2019 hybrids the equivalent fault of the heater-loop sensor ECT2 is P2184, recorded after 5 seconds of driver fault status. CARB requires out-of-range detection for such temperature inputs. The module may then run pumps or fans on safe defaults. P0E84 is the opposite, a reading stuck cold; P0E82 covers values inside the range that are implausible.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 83

Possible causes

  • Sensor signal wire shorted to ground high
  • Internally shorted sensor A medium
  • Genuinely very hot coolant in the auxiliary loop low

Symptoms

  • Check engine light
  • Coolant pump or fan running continuously
  • Implausibly high temperature shown on a scan tool

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0E83

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication