OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E77

Coolant Bypass Valve A Control Circuit High

P0E77 is logged when valve A's drive line carries more voltage than the driver should allow, typically because the wire has rubbed through against a 12 V feed. A low-side driver then sees battery voltage while it is trying to pull the line down and usually reports overcurrent; with some designs an open line can float high and end up here too. In either case the valve no longer follows commands reliably. No manufacturer documents P0E77 publicly. Ford's 2019 hybrid summary handles the same situation on its bypass valve as P2683, again set after more than 5 seconds of driver fault status. CARB expects such outputs to be checked for circuit faults. A grounded line is P0E76 and an interrupted one P0E75; replacing the valve without checking the harness first rarely helps.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 77

Possible causes

  • Control wire shorted to a battery or ignition feed high
  • Open circuit that the driver interprets as high medium
  • Faulty valve A actuator electronics low

Symptoms

  • Check engine light
  • Cabin heat unstable or missing

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0E77

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication