P0E76
Coolant Bypass Valve A Control Circuit Low
With P0E76 the voltage on the control line of coolant bypass valve A stays lower than the driver expects for its current state, which points to a short to ground somewhere in the harness or inside the actuator. What happens next depends on the driver layout: a low-side output may leave the valve energised all the time, a high-side output can no longer move it at all, and the driver may switch off to protect itself. No manufacturer documents P0E76 publicly. In Ford's 2019 hybrid summary the matching job falls to P2682, flagged once the driver has signalled a fault continuously for over 5 s; only after that does Ford run its stuck-valve check P26AB. CARB requires circuit monitoring of output devices like this one. P0E77 is the high case, P0E75 an open; P0E79 and P0E7A cover a valve that is mechanically stuck.
Possible causes
- Chafed control wire touching body or engine ground high
- Internal short in the valve A actuator medium
- Moisture bridging pins in the valve connector low
Symptoms
- Check engine light
- Valve stays in one position, heating behaves oddly
- Possible blown fuse if the short is hard
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0E76
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.