P0E73
Control Pilot Signal High Frequency
P0E73 is set when the control pilot pulses from the charging station arrive faster than the nominal 1 kHz. Above the permitted band the vehicle can no longer be sure that it decodes the duty cycle, and with it the allowed charging current, correctly; in practice it refuses or ends the session. Short spikes or ringing on the pilot line can mimic extra edges and be counted as a higher frequency, so cable condition and nearby interference matter as much as the station itself. No manufacturer documents P0E73 publicly. Simulation notes from Typhoon HIL describe the station side of this interface, a PWM signal of ±12 V at 1 kHz evaluated by a resistor network in the car. If the fault follows the vehicle across several stations, check the charge port and the charger's input. P0E72 is the low case.
Possible causes
- Electrical interference or ringing on the pilot line medium
- Charging station with a faulty pilot oscillator medium
- Damaged charging cable or corroded charge port pin medium
- Faulty pilot input in the on-board charger low
Symptoms
- AC charging refused or stopped shortly after start
- Fault tied to a specific station or cable
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0E73
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.