P0E70
Battery Charging System Precharge Contactor Control Circuit High
P0E70 is the high-side counterpart of P0E6F: the coil line of the charging precharge contactor carries voltage although the driver is off. A short to a 12 V feed can energise the coil without a command, which would let the precharge branch conduct unasked; the battery management therefore usually locks out charging. No manufacturer documents P0E70 publicly. For its positive charging contactor GM tests exactly this case in the 2019 hybrid tables (P0D0A): with the driver off, an output voltage above the 12 V battery voltage minus 0.4 V counts as a short to power, confirmed by 40 of 50 samples at 12.5 ms, Type B. Mitsubishi's i-MiEV sets P0AE7 when the coil monitor stays on after an off command. An open coil circuit is P0E6D.
Possible causes
- Coil control wire shorted to a 12 V supply high
- Driver stage in the battery management unit stuck on medium
- Open ground return of the coil leaving the line at supply level low
Symptoms
- Charging locked out with a high-voltage fault message
- Contactor clicks without a charging request
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0E70
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.