P0E66
Battery Charger Control Circuit Low
With P0E66 the controller finds the charger command line pulled lower than the state it is driving, which typically means the wire touches ground somewhere between the control unit and the on-board charger. If the command is active-high, the charger simply never receives it; a grounded line can also overload the output stage that drives it. No manufacturer documents P0E66 publicly. GM's Volt and 2019 hybrid tables check this line only through the general code P0E65, based on a hardware fault flag sampled every 25 ms at 10.2 V or more. California's OBD rule requires plug-in hybrids to recognise charger faults that stop or limit charging. P0E67 is the opposite case, a line stuck high; P0E68 covers a line that is electrically sound but answers wrongly.
Possible causes
- Control wire chafed through to body ground high
- Moisture in a connector bridging the signal to ground medium
- Internal short in the charger's command input low
Symptoms
- Charging does not start after plugging in
- Charge indicator shows a fault or goes out
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0E66
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.