OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0E65

Battery Charger Control Circuit/Open

P0E65 flags a fault on the wired command line through which the hybrid control unit operates the on-board charger, most often an interrupted line. GM uses it codegenau: in the 2016 Volt the VICM runs the test, in the 2019 hybrid tables (19OBDG01) the HPC2 module. The check relies on a fault flag raised by the output driver hardware itself and only runs while system voltage is 10.2 V or higher and the charger enable mask is active. Samples are taken every 25 ms; 30 bad ones among 40 store the code. GM classes it Type B, so the MIL comes on once the fault returns on a second trip. Low, high and plausibility faults on the same line have their own codes, P0E66 to P0E68. Plug-in charging is usually refused until the line is repaired.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberE / 65

Possible causes

  • Broken or disconnected charger control wire high
  • Corroded or pushed-out terminal at charger or control unit medium
  • Defective output driver in the commanding control unit low

Symptoms

  • Vehicle does not charge when plugged in
  • MIL after the second trip with the fault (GM)
  • Charging fault message in the instrument cluster

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0E65

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication